What hooks do burbot like?
September 22, 2022Why should the burette be rinsed with NaOH before it is filled?
September 22, 2022Check the tip of the buret for an air bubble. To remove an air bubble, whack the side of the buret tip while solution is flowing. If an air bubble is present during a titration, volume readings may be in error. Rinse the tip of the buret with water from a wash bottle and dry it carefully.
Related
- What do you clean a buret with? Rinse with distilled water: With the stopcock closed, add some distilled water to the buret. Rinse with solution:. After you are finished with the buret in your experiment, rinse it by filling it with distilled water and allowing it to drain.
- When rinsing a buret after cleaning it with soap water should the rinse? When rinsing a buret after cleaning it with soap and water, should the rinse be dispersed through the tip or the opening on the top? In preparing the buret for titration, the final rinse is with the NaOH titrant rather than the deionized water. Why? When rinsing a buret, the water and rinse should go through the tip.
- Why a titration flask should not be rinsed? This is because during rinsing some liquid will remain sticking to titration flask , therefore the pipetted volume taken is the titration flask will increase .
- When rinsing a burette after cleaning it with soap and water should the rinse be dispensed through the burette tip or the top opening of the burette Why? After cleaning a buret with soap and water, it is always rinsed with the titrant. In doing so, the rinsing solution must be dispensed through the buret tip as this will help in keeping the concentration of titrant same.
- Why removal of air bubbles is necessary before titration? Answer and Explanation: Good laboratory technique is critical when manually performing titrations. If you have air bubbles in the burette column, then the initial volume will have an error upon reading since part of that volume is occupied by the bubble rather than the titrant.
- Why are air bubbles in the buret bad? Air bubbles are trapped in burette and tubes. They lead to inaccurate dosing where the system believes the bubble is titrant and gives falsely high results. Furthermore air bubbles of different sizes lead to result variation.
